2014 Chevrolet Traverse Oil Change in Murray, UT

Plan for about 60 minutes for a dealership oil change with inspection.

This allows time for check-in, draining and refilling, installing an OEM-spec filter, and a multi-point inspection tailored to Utah driving. At Larry H. Miller Chevrolet Murray in Murray, most customers are in and out the same visit. You can select a time and minimize wait by booking online.

• Schedule your appointment: schedule service
• Address: 5500 S State St, Murray, UT 84107
• Includes oil, filter, and a multi-point inspection

Follow the Oil Life Monitoring System, typically up to 7,500 miles under normal use and about 5,000 miles in severe Wasatch Front conditions.

Utah’s cold starts, mountain grades, dust, towing, and stop-and-go traffic can shorten intervals. Watching the oil-life display and servicing proactively helps protect the 3.6L V6 and AWD driveline. If your driving fits severe duty, change oil more frequently.

• Normal: up to ~7,500 miles per OLM guidance
• Severe duty: about 5,000 miles or as indicated sooner
• Book online at schedule service

Use SAE 5W-30 that meets GM dexos1 specifications (full synthetic is commonly used).

This viscosity balances cold-start flow for Utah winters and high-temp protection on summer canyon drives. Using oil that meets GM’s dexos1 standard helps maintain performance and support warranty requirements. Our team installs OEM-spec oil and a GM-quality filter.

• Viscosity: SAE 5W-30 (dexos1-approved)
• OEM-spec oil and filter installed
• Documented service at Larry H. Miller Chevrolet Murray

The 3.6L V6 typically needs about 6.0 quarts of oil with a filter change.

Capacity can vary slightly by filter and drain time, but about six quarts fills the system to spec when serviced properly. Our techs verify level after installation and again once the engine is warm to ensure accurate fill.

• Approximate capacity: ~6.0 quarts with filter
• Level verified hot after installation
• Includes eco-friendly oil and filter disposal

For GM dexos1 5W-30, an OEM-quality filter, and documented service by OEM-certified technicians, the dealership offers added assurance.

Quick-lube shops may be faster or lower cost, but parts and oil quality can vary. Dealer service uses OEM-spec materials and records your visit to help with future warranty support and resale confidence.

• OEM-spec oil and GM-quality filter included
• Multi-point inspection and fluid top-offs
• Service history captured to your VIN

Skipping required oil services can lead to denied warranty claims on lubrication-related engine repairs—keep dated service records.

OEM maintenance schedules expect timely oil changes and proof of service. Warranty work generally requires a certified facility and documentation that the correct oil and filter were used. We store digital records tied to your VIN.

• Follow OLM guidance and severe-duty adjustments
• Use dexos1 5W-30 and an OEM-quality filter
• Keep receipts and maintain a consistent service history

Full synthetic 5W-30 (dexos1) resists oxidation and shear better than conventional or blends, especially in Utah heat and cold.

Full synthetic maintains viscosity across temperature swings, supporting cold-start pumpability and high-load protection on mountain passes. Blends improve over conventional but don’t match full synthetic stability. Using oil that meets GM’s dexos1 standard is the key requirement.

• Better cold-flow for winter starts
• Improved high-temp stability under towing
• Meets GM dexos1 performance targets

Book in under 2 minutes at /service/scheduler.htm and visit 5500 S State St, Murray, UT 84107.

We serve the greater Salt Lake City area, including South Jordan, West Jordan, Midvale, and Sandy, with OEM-certified care. Check current offers before you arrive to maximize value.

• Online booking: schedule service
• Service specials: service specials
• Factory-authorized Chevrolet maintenance

For a 2014 Chevrolet Traverse, our oil change follows a standardized, OEM-focused process that supports reliability in Utah’s varied climate. After confirming your concerns and reviewing mileage, we safely lift the vehicle, drain the used oil, replace the drain seal as needed, and install an OEM-quality oil filter. We then fill with SAE 5W-30 that meets GM dexos1 performance requirements and verify the level. A multi-point inspection checks brakes, tires, steering/suspension, lights, belts, and visible leaks. We top off fluids, set tire pressures, reset the Oil Life Monitoring System, and document the visit to your VIN. Disposal of used oil and filters is handled responsibly. Review current offers, then schedule service to lock in a time that works for you; see our service specials for potential savings.

The 2014 Chevrolet Traverse with the 3.6L V6 is engineered for SAE 5W-30 oil that meets GM dexos1 standards, with full synthetic commonly used for added temperature stability. The system typically holds about 6.0 quarts with a filter change. Under normal operation, follow the Oil Life Monitoring System (often up to ~7,500 miles); for severe duty around the Wasatch Front—frequent short trips, heavy traffic, dust, towing, or steep grades—service closer to ~5,000 miles. An OEM-quality filter maintains proper flow and capture efficiency; our team confirms fitment for your VIN. If you have questions about oil performance or any technical bulletins, we’re happy to review them during your visit. Bring your 2014 Chevrolet Traverse to Larry H. Miller Chevrolet Murray in Murray for an OEM-spec oil change — schedule service.

Larry H. Miller Chevrolet Murray serves the greater Salt Lake City area, including South Jordan, West Jordan, Midvale, and Sandy, with factory-authorized maintenance tailored to Utah’s climate and driving. Cold-start pumpability matters in winter; in summer, high canyon grades and towing add heat that stresses oil. Dust from dry conditions and stop-and-go on I-15 can also shorten service intervals. Our OEM-certified technicians use Chevrolet-approved oil and filters, perform a multi-point inspection, and record the visit for your maintenance history. We make it easy to book, arrive, and get back on the road quickly. For directions, set your GPS to 5500 S State St, Murray, UT 84107, review current service specials, and schedule your appointment today.